MRS 26CC Zenoah - Race Ported

MRS 26CC Zenoah - Race Ported
Product Code: MRS0001
Availability: In Stock
Price: $869
Qty:        
Winner of the Europian Championship 4WD - 2014!!
Winner of the Europian Championship 2WD - 2015 & 2017!!
 
Tuned engine 26CC from MRS based upon the Zenoah. With cylinder- and piston porting plus a modified flywheel.
Features: very low fuel consumption, high torque in lower rev area and reaches high RPM. Fully CNC machined.
Read before the directions of use for a long life time cycle and optimum performance.

 

On this engine there is made modifications mainly for the flow of the fuel mixture, balance of the engine and squish. After a testing  period of 1½ year this powerhouse with very low fuel consumption is now released to the market.

The piston is machined inside and outside. Inside for a reduction of weight. Outside for an optimalisation of the flow of the fuel mixture. The piston has 4 extra transfer ports made in axial direction, which enlarges the area of flow and smoothens the flow of the fuel mixture towards the combustion chamber. Not only a higher volume can flow through, also lubrication is optimized, which pro longues the life time of the piston. The outside diameter directly above and under the piston ring is slightly trimmed. This results in a better lubrication of the piston ring and piston. As last modification, the top of the piston has been trimmed for compensating the increased compression as a result of the cylinder tuning.

The cylinder has been trimmed at the bottom to reduce the squish and setting the timing of the ports correct. The cylinder is mounted to the crank housing with liquid gasket. Inside the cylinder is only machined very little on the exhaust port, for timing purpose and maintaining a correct pulse. This helps to reduce the fuel consumption. At the transfer ports the eye-brows have been machined, inside the EFRA regulations set for inlet porting. Also the seperation wall of the transfer ports have been modified for higher volume and optimized flow properties of the fuel mixture. All modifications are carried out by CNC for repeatability and identical tuning on each engine.

The flywheel has been modified on purpose asymetric, for optimized balance and increased performance, helping acceleration. The fans on the flywheel are not machined, to maintain a maximum of cooling air directed over the cylinder.

A small modification is also made on the isolator mounted on the engine, for an improved flow of the fuel mixture.

 

Directions of use:

At first use, start with following needle settings of the carb:

L needle:  1 1/8 turn opened

H needle:  1 5/8 turn opened.

The first time let the engine iddle for about 10 minutes, after this cool down engine.

Drive with the engine for 10 minutes, do not open throttle more then 1/3rd, cool down engine.

Drive 2 tanks with around maximum 3/4rd throttle open.

Never let the engine rev towards the top end of its RPM when running in. When the engine is going to reach the top of its rev, directly go back to iddle.

CAUTION:

Always iddle the engine for about 2 minutes and/or keep your RPM low when cold. This is essential, as the piston is highly modified and is of significant lower mass. Due to being less material present, the piston will heat up much quicker and so it expands quicker as well. Directly going high revs or running full throttle with a cold engine might lead to excessive wear and/or damage of the piston and/or cylinder.

Lubrication 1:25 is advised using a full synthetical 2-stroke racing oil.

Delivered excl air filter, excl clutch, excl. exhaust.

Inclusive carb and isolator

Powered By OpenCart
KingRC © 2024